Phase Setup

Configure how each phase should run. Event Setup controls which phases are active, which day they run and their start times. This page controls the detailed parameters for Shooting, Swimming, Running and Riding.

Shooting settings (Details)

The number of targets on the range defines the maximum number of competitors in each Detail. Class-specific distances and target types come from the class requirements.

Number of targets (firing points)
Max competitors per Detail	Equal to the number of targets (currently 8 per Detail).
Left-handed shooters on end targets	Always place left-handed shooters on end targets if possible.
Gun share separation	Do not place gun-sharing competitors in the same Detail.

Swim settings

Basic pool configuration. These settings will drive automatic lane/heat assignment and warm-up blocks. The number of lanes is the maximum swimmers per heat.

Number of lanes
Changeover between heats (buffer, minutes)	Extra time after each swim to clear and line up the next heat. Default is 1 minute.
Order of swim heats by speed

Swim warm-ups (either automatic or manual)

Warm-ups are time blocks before heats. Set a warm-up length, then choose either:
• Automatic – every N heats
• Manual – before specific heat numbers
Always leave one of these options “off” (0 or blank).

Warm-up length (minutes)	0 = no warm-ups. If > 0, a warm-up will always be scheduled before the first heat.
Automatic warm-ups – every N heats	Example: 3 ⇒ additional warm-ups before heats 1, 4, 7, … Leave as 0 if you prefer to use manual warm-ups instead.
Manual warm-ups – before specific heats	Comma-separated heat numbers, e.g. `5, 10, 15` to insert warm-ups before those heats. Leave this blank if you are using automatic every-N-heats warm-ups instead.

Swim lifeguard breaks

Lifeguard breaks are based on elapsed session time, including warm-up blocks and buffers. After each duty period the system will schedule a break of the given length.

Give lifeguard a break every	hours minutes Default is 1 hour 30 minutes. Set both to 0 to disable scheduled lifeguard breaks.
Length of lifeguard break (minutes)	Default is 15 minutes.

Run settings

Configure whether the run is individual starts or grouped heats, and how large those heats should be.

Run mode
Gap between individual starters (seconds)
Max runners per heat (if heats)
Order of heats by speed

Ride settings

Ride-down settings. Heights come from class requirements; this simply controls how ride-down entries are flagged on ride sheets.

Allow ride-down	Allow competitors to elect to ride a lower height.
Show ride-down label on ride sheets	Mark ride-down competitors clearly on printed ride sheets.

← Back to Main Menu